Page 11
For technical questions, please call 1-888-380-0318.
Item 64806
Sa
FE
ty
W
E
lding
t
ip
S
Maint
E
nanc
E
tig
/ Stick
c
ontrol
S
Wir
E
6.
10-12 pound Wire Spool installation:
Remove the Wingnut, Keyed Washers, and Spring.
If replacing a Spool, remove the old Spool
and all remaining wire from the liners.
7. Place the Spool Adapter over the Spool Spindle
and against the Spool Brake Pad as illustrated.
8. Place the new Wire Spool over the Adapter and
line up pin on Adapter with hole in Spool.
to prevent wire feed problems, set the Spool
so that it will unwind counterclockwise.
9. Line up the Keyed Washers with the groove
on the Spindle. Replace the Keyed Washers
and Spring over the Spool Spindle and
secure Spool in place with the Wingnut.
notice:
If Wire Spool can spin freely, Wingnut
is too loose. This will cause the welding
wire to unravel and unspool which can
cause tangling and feeding problems.
10. Screw the Spool Knob into the Spool Adapter.
11.
dcEn direct current Electrode negative
Wire Setup for Flux-Cored (gasless) welding:
Connect the Wire Feed Connector to the
Negative Terminal on the front of the Welder.
Connect the Ground Cable to the
Positive Terminal on the front of the Welder.
10-12 lb Spool loading
Welder
Wall
10-12 lb
Spool
adapter
Wingnut
keyed
Washer
Spring
keyed
Washer
10-12 lb
Wire Spool
Spool knob
Wire
must
unwind
in this
direction
dcEn
Flux-Cored (Gasless) Polarity Setup
connect
Wire Feed
to negative
connect
ground to
positive