22
Remote Controller Behavior:
If the remote controller is unable to communicate with the remote sensor
after the control network has already been formed, it will show dashes for
all readings and NETWORK 0 in the lower right-hand corner.
When wireless communication has been re-established and is functioning
properly, the network code will be cleared and the display will function
normally.
Remote Sensor Behavior:
On power-up the remote sensor will search for the remote controller via
wireless network; during this time the LED will illuminate
yellow
. The
behavior of the LED will indicate its current function as described in Table 3
of the Codes and Errors section of this document.
When wireless communication has been re-established and is functioning
properly, the LED will illuminate
green
and behave as described in Table 3
of the Codes and Errors section of this document.
Range Testing:
Under ideal conditions (i.e. line of sight, no metallic interference, low
humidity, etc), the Hyperion
®
2 is capable of communication up to 150+
feet. Environmental changes and obstacles (particularly ones made of
metal) will reduce maximum communication range. To test the signal
strength between the modules, follow these steps:
1. Power-up both the sensor and remote controllers.
2. Press and hold the Select button of the remote controller until the
screen goes blank and only the NETWORK icon and a number begin
to blink in the lower right-hand corner of the display. The number
shown indicates the signal strength between the two modules and is
described below:
3. After 10 seconds with no buttons pressed, the remote controller will
return to showing the current room’s environment.
-1
Remote controller is attempting to rebuild network (refer to
Rebuilding The Wireless Network section on the next page): no
signal strength information is available.
0
Very low signal strength or no signal detected.
1
Good to moderate signal strength.
2
Strong signal strength.