12
To Reset the Light Odometer and Clear the Change Bulbs Icon:
1. Follows steps 1 through 3 (on page 11) to display the current number
of hours logged on the light odometer.
2. Press and hold the Select button for 5 seconds while the display is
showing the current odometer reading. The displayed reading will be
reset to 0 and the Change bulbs icon will be cleared.
NOTE:
*It’s recommended you reset the light Odometer every time you replace
your lamps.
*The remote controller will not show the current time if the Low Battery icon
is displayed: this will also prevent the Hyperion
®
2 from running the lighting
schedule. Refer to the SETTING THE CURRENT TIME section below for
instruction on how to replace the battery and reset the remote controller’s
time.
Setting the Current Time:
To avoid making any changes, allow 5 seconds with no buttons pressed at
any time during this procedure: the display will stop blinking and the system
will return to normal operation.
1. Follow the steps in the ‘Checking The Hyperion
®
2 Control Parameters’
section and select TIME.
2. Press the Select button and the hours will begin to flash.
3. Use the Up and Down buttons to adjust the hours to the correct value.
The AM/PM icons will change with adjustments to the hours. When the
correct hour has been selected, press the Select button and minutes
will begin to flash.
4. Use the Up and Down buttons to adjust the minutes to the correct
value. Press the Select button and the display will go blank
momentarily to indicate the time adjustment has been completed.