7.2 Connection of barrier arm lighting
1. Remove the side arm plug;
2. Pull the
from the electronic control unit through hole
1
in barrier cabinet, hole
2
in arm holder, hole
3
cable
a
in arm;
3. Carefully, without damaging, pull the lighting wires out of the hole in arm, connect terminal block with arm
lighting
and with
;
cable
b
cable
a
4. Check their placement in arm;
7.3.
Installation and connection of IR barriers (safety sensors)
Safety sensors can be mounted on posts (included in the optional scope of delivery).
Do not install posts too close to the edge of roadway, recommended distance is at
least 10 cm, in order to avoid damage when driving through boom barrier. To form the
control zone outside the arm of boom barrier, two posts are installed on opposite sides of
roadway: a transmitter is mounted on one post, a sensor receiver is on the other.
Place the receiver and transmitter of the safety sensors
turn on each other.
Make the connection in accordance with diagram in Appendix 2 (OM, Part II).
Entry IR barriers are connected to the controller in the electronic control unit to
terminal block
X5.INP1
to the inputs of the safety sensor input 25.INP "SAFETY 1" 1
and exit 26.INP "SAFETY 2" 1 or to the terminal block
X7.INP2
to the inputs of safety
sensor of input 55. INP "SAFETY 1" 2 and exit 56. INP "SAFETY 2" 2.
А
Вид А
a
b
1
2
3
Page
-19-
Size А4
Installation and Operation Manual
Revision 1.0 2021
ROAD BLOCKING SYSTEMS
Office and Production site:
Tel.:
+380 (44) 291-21-11
14 Promyslova str., 02088, Kyiv, Ukraine,
Fax:
+380 (44) 291-21-02
E-mail:
[email protected] www.tiso.global
BOOM BARRIER OPTIMUS
