Dishwasher
User Manual
Page
23
Installation
3. Turn the water supply fully on before
starting the dishwasher.
Disconnecting the safety supply hose
The safety supply hose system blocks the
flow of water in the case of the supply hose
breaking, or when the air space between the
supply house and the outer corrugated hose
is full of water.
1. Turn the water supply completely off
2. Unscrew the safety supply hose from the
faucet.
WARNING //
A hose that attached to a sink
spray can burst if it is installed on the same
water line as the dishwasher. If your sink
has one, it is recommended that the hose be
disconnected and the hole plugged.
Connecting the water inlet hose
Connect the cold water supply hose to a
threaded ¾” connector and make sure that it
is fastened tightly in place.
If the water pipes are new or have not been
used for an extended period of time, let water
run through them before attaching the hose
to them to make sure that the water is clear
and free of impurities. If this precaution is not
taken, there is a risk of the water inlet getting
blocked, which could damage the appliance.
Connecting the water outlet
Insert the hose into a drainage hose with
diameter greater than 40mm or into a sink, in
both cases, make sure that the outlet pipe is
straight and not higher than 1m from the floor.
Secure your hose firmly to the drainage pipe to
avoid it coming off during the washing process.
If the length of the hose is not sufficient,
a hose extension can be ordered from an
authorised service agent.
NOTE //
The hose length, including the
extension, should not exceed 4 meters.
ATTENTION //
If the end of the outlet hose is
positioned at a height above 1m from the floor,
the excess water in hoses cannot be drained.
Connecting the drain hose
The drain hose with a minimum diameter of
40mm must be inserted into a drain pipe
(A)
or
must be positioned to run into the sink without
bending or crimping
(B)
. The top of the hose
must be less than 1m, and the hose height must
not exceed 1m from the floor. The water drain
hose should be fixed using a hose clip.
Please connect the
drain hose either way
of A or B