Page
22
Dishwasher
User Manual
ATTENTION //
Connection to the water and
electrical supplies should only be performed
by a qualified technician.
WARNING //
Switch off the electrical power
before installing the appliance. Failure to do
so can result in electrical shock or death.
Product dimensions
Dishwasher Installation
NOTE //
This section is a quick guide of
the installations steps, please refer to the
following pages for more details of each step
listed below:
Position and leveling
1. Remove the appliance from the packaging
and check its conditions. If the dishwasher
has been damaged during transportation,
please contact the retailer and do not
resume the installation.
2. Position the dishwasher in a way so that
its sides and back panels are not in contact
with the adjacent cabinets or with the wall.
This appliance can also be recessed under
a bench top.
3. Position the dishwasher on a level and
sturdy floor. If the floor is uneven, the
three leveling legs of the appliance can be
individually adjustconed until it reaches
a horizontal position. If the appliance is
leveled correctly, it will be more stable
and much less likely to move or cause
vibrations and noise while in operation.
Water supply connections
The dishwasher should not stand on top of
the water hoses or electric supply cable. The
appliance must be connected to the water
supply network using new piping.
Connecting the safety supply hose
The safety supply hose system blocks the
flow of water in the case of the supply hose
breaking, or when the air space between the
supply house and the outer corrugated hose
is full of water.
NOTE //
The appliance must be connected
to the water mains using new hose-sets. Old
hose-sets should not be reused
NOTE //
Water pressure must be between 0.04
MPa and 1 MPa.
1. Pull the safety supply hoses completely
our from the storage compartment located
at dishwasher rear.
2. Tighten the screws of the safety supply
hose to the faucet with a threaded ¾”
connector
Installation