25 of 90
Stop the vehicle as soon as the clearance between the rear wall of your carrier vehicle and sponge
rubber
1
of the cabin is maximum 3 cm.
Lowering the cabin using the crank supports
Lower the cabin by turning the crank supports counterclockwise. First retract the rear supports
followed by the front supports.
Attention
Risk of damage
•
Make sure to never raise the rear of the cabin higher than the front.
This could result in the alcove resting on the roof of your carrier
vehicle.
•
Start lowering the cabin using the rear supports.
Once the supports are completely retracted, loosen cotter pin
1
, pull out bolt
2
and insert attachment
part
3
into the support. Stow pads
4
in the vehicle.