TIPTEL 822XT, Installation Instructions Manual

Page: 64 / 100

Configuration menu: Subscriber
64
Note: If the same subscriber receives a second call during an active conver-
sation (LED on), this status is indicated by a flashing LED. This means
that the second incoming call (waiting call) can be picked up.
Speed dialling key
It is possible to enter any destination number here. This destination number will be
dialled when the function key is pressed.
Call forwarding: unconditional
Enter the call number of the forwarding destination (internal or external) here. By
pressing the function key, direct call forwarding to the indicated subscriber is acti-
vated for your system telephone. Incoming calls are no longer signalled on your tele-
phone. The status is indicated by the LED as follows:
•
LED on => call forwarding is active
•
LED off => call forwarding is not active
Call forwarding no response
Enter the call number of the forwarding destination (internal or external) here. When
the function key is pressed, your system telephone will engage a delayed forwarding
for the specified subscriber. The telephone rings for 15 seconds (pre-set parameter,
time can be set according to individual requirements) before the incoming call is for-
warded to the programmed destination number. The status is indicated by the LED
as follows:
•
LED on => call forwarding is active
•
LED off => call forwarding is not active
Call forwarding: busy
Enter the call number of the forwarding destination (internal or external) here. When
the function key is pressed, your system telephone engages forwarding if the speci-
fied subscriber is busy. The status is indicated by the LED as follows:
•
LED on => call forwarding is active
•
LED off => call forwarding is not active
Call forwarding delayed & busy
This is a combination of the two functions mentioned above. Both call forwarding op-
tions have the same destination. If two different destination numbers should be en-
tered, one key has to be assigned to each type of call forwarding.