TINKERINE
STUDIO
STUDIO
[email protected] | 1-604-288-8778
51
1.
2.
Place the bottom portion of the extruder onto
the carriage and insert the hotend
mount into the center of the carriage through
the slot located on the back on the carriage.
With the two M3x20 screws, secure the
extruder and hotend to the top plate of the
carriage. The screws should thread into the
hotend mount, securing all the components
together.
Ensure that the acrylic spacer is attached to
the top of the hotend and leave the ceramic
insulation wrapping attached to the hotend.
From the front, your carriage should now look
like this. Make sure the larger portion of the
extruder is on the left side. The extended
portion of the hotend should also be pointing
toward the left.
M3x25 (x2)
Acrylic Spacer
Hotend mount
