1.
M3x20 (x2)
M3x20 (x2)
M3x25 (x2)
TINKERINE
STUDIO
STUDIO
[email protected] | 1-604-288-8778
26
Install each endstop triggers as shown. Note the orientation of
the trigger and the direction its pointing. Depending on the
trigger, you will need to different amounts of spacers with the
endstop.
After the endstop trigger is installed. Thread the
wires through the holes shown in the picture. Use
one of the smaller adhesive wooden clips provided
in your kit to prevent the wire from slacking/getting
caught once the printer is in motion. Insert the wire
into the clip and tape it to the bottom side of the top
ring beside the LED strip.
