Timewave DSP-599zx, Operating Manual

Page: 86 / 106

7 – Test Instrument Operation
7-10 March 6, 1997
4. Rotate left knob until &7&66 7KUHV appears on the bottom left of
the display
5. Press the left knob to select.
6. Rotate left knob until the chosen value appears on the bottom right of
the display
7. Press the left knob to accept choice and save. Press middle knob to
escape without saving changes.
8. Rotate left knob until your next function to change appears on the bot-
tom line of the display or press the middle knob to return to main set-
up menu.
Signal Generator Calibration
This unit was delivered to you calibrated. If for some reason you decide that
you need to re-calibrate the outputs and inputs on the DSP-599zx, do it with
great care. Resetting the unit has no effect on these settings. Use a high qual-
ity digital multimode VOM meter, such as a Fluke 8060 or equivalent. It
takes a unit of this caliber to be accurate at the 1 kHz calibration tone. Adjust
meter to read AC voltage with a range of 0 - 2 volts.
1. Connect a Fluke 8060 or equivalent to channel A line output. Set meter
to AC volts, in the appropriate range to read the required voltage.
2. Press [Shift+Mode] twice to enter Setup mode.
3. Rotate left knob until 7HVW appears on the bottom line of the display
4. Press the left knob to select.
5. Rotate left knob until $GM /LQH $ P9 appears on the bottom
line of the display
6. Press the left knob to select.
7. Rotate left knob until the reading on the meter reads 64 millivolts.
8. Press the left knob to accept choice and save. Press middle knob to
escape without saving changes.
9. Rotate left knob until $GM /LQH $ P9 appears on the bottom
line of the display
Function
6
Shift
5
AGC
3
Bypass
Setup Test Data
DSP-599zx
CW Voice
Mode
Rcl/ Store
Spkr/ Chan
1
Random
4
Tone
2
599-085
High Pass
Center Freq
Time