Timewave DSP-599zx, Operating Manual

Page: 5 / 106

DSP-8100c Audio Noise Reduction Filter
March 6, 1979 Quick Start-v
Quick Start Setup
Here is the absolute minimum information you need to get started. After you
satisfy your urge to hook it up and turn it on please read the entire manual.
There are two reasons for the request. First; you will learn how to maximize
the effectiveness of this fine product. Second; you paid for this manual so
you might want to get your money’s worth.
1. Before connecting the DSP-599zx, tune in a signal on your receiver
and adjust it for your normal listening level.
2. Connect the speaker output of your radio to Channel A audio input of
the DSP-599zx. Use a RCA phono connector on the DSP-599zx end
of the cable.
3. Connect the Channel A audio output to your 4 or 8 ohm loudspeaker.
Use a RCA phono connector on the DSP-599zx end of the cable.
4. Connect a 12-16 Vdc 1 Ampere power supply to the DSP-599zx. Use
a 5.5 x 2.1 mm power connector on DSP-599zx end of the 12-16 Vdc
power cable. The center pin must be positive (+). (There is a 5.5 x
2.1 mm connector packed with the DSP-599zx manual.)
5. Turn on the DSP-599zx power (volume control, right side of front pan-
el).
6. Adjust the radio volume control until the yellow LED on the right side
of the DSP-599zx panel flashes but the red LED flashes rarely.
7. Adjust the DSP-599zx volume control for comfortable listening.
8. Select the Voice, CW or Data mode on the DSP-599zx by pressing the
Mode switch on the upper left front panel to light the corresponding
LED above the display.
9. Try pressing the random noise reduction and tone notch switches, and
adjusting filter tuning knobs to operate the various filter features of the
DSP-599zx.
10. You can select many more features by using the rest of the switches
and the display menus.
For best results, read the manual now!