Quick Setup: SyncBac PRO
If you are familiar with SyncBac PRO settings, you can quickly set up your SyncBac
PRO by following the procedures below.
l
Quick Setup: SyncBac PRO as Slave (see page 14)
l
Quick Setup: SyncBac PRO as Master (see page 15) .
If you are new to SyncBac PRO, you should follow the same steps, but refer to the
more detailed sections for more information.
Quick Setup: SyncBac PRO as Slave
If you want your SyncBac PRO to have its clock set by another device, such as
another SyncBac PRO or a :pulse, set it to run as an RF Slave.
1.
Connect SyncBac PRO to a GoPro HERO4™ (see page 16)
.
2. Switch your SyncBac PRO on (see
Switch SyncBac PRO On and Off on page 17
3.
Set the RF Country/Area (see page 19)
.
This is important as your SyncBac PRO has to be set to use the appropriate
frequency range for your country.
4. Set the
Timecode Mode
to
RF Slave
(see
Set the Timecode Mode on page 20
).
This is important as it defines how your SyncBac PRO synchronises with other
devices.
Timecode devices use a master-slave relationship for synchronisation. If this
concept is new to you, you can find explanations in
.
5.
Set the RF Channel (see page 28)
.
The
RF Channel
defines which BLINK network your SyncBac PRO will be a
member of, and therefore, which master or slaves it can communicate with.
When you have completed these steps, you have applied the minimum required
settings for your SyncBac PRO in RF Slave mode. But to work with its attached
GoPro HERO4™, the SyncBac PRO must first synchronise with a master device. If
there is no master device in your BLINK network, you will need to set one up and
make sure your SyncBac PRO is in range so that it can synchronise for the first time.
14
SyncBac PRO User Guide
Summary of Contents for SyncBac PRO
Page 6: ...vi SyncBac PRO User Guide...
Page 58: ...58 SyncBac PRO User Guide...
Page 63: ...SyncBac PRO User Guide 63...
