Timberwolf TW SX200, Manual

Page: 11 / 57

OPERATING INSTRUCTIONS
10
TIMBERWOLF
TW SX200
All Timberwolf TW SX200 machines have a full pre - delivery inspection before leaving the factory and are
ready to use. Read and understand this instruction manual before attempting to operate the shredder.
In particular, read pages 6 -8 which contain important health and safety information and advice.
CHAINSAW safety helmet fitted with visor
and recommended ear defenders to an
appropriate specification.
HEAvy-DUTy gloves with elasticated wrist area.
CLOSE - FITTING heavy-duty non-snag clothing.
SAFETy footwear.
FACE MASK (if appropriate).
See page 6 for more detailed information.
Roller control boxes- two control boxes are located on either side of the feed funnel. Their function is
to control the feed roller* whilst processing material. They do not control the main drum.
RED SAFETY BAR = This is the large red bar that surrounds the feed funnel. The bar is spring loaded
and connected to a switch that will interrupt the power to the roller. The switch is designed so that it
only activates if the bar is pushed to the limit of its travel. The roller will stop instantly, but can be made
to turn again by pressing either the GREEN FEED or BLUE REvERSE control buttons.
RED SAFETy BAR TEST
To ensure the safety bar is always operational it must be activated once before each work session.
OPERATOR’S PERSONAL PROTECTIVE EQUIPMENT REQUIRED
MANUAL CONTROLS
WARNING
DO NOT remove, jam, disable, bypass, override or otherwise
impede the effectiveness of the red safety bar.
GREEN
FORWARD
FEED
PANEL
BLUE
REVERSE
FEED
PANEL
RED SAFETY BAR
Control Box Diagram
Do not rely on the red bar to keep the in-feed roller*
stationary if it is necessary to clear or touch either.
Always switch off the machine and remove ignition key
before approaching the in-feed roller.*
There are two control
boxes, located on either
side of the feed funnel.
*in-feed roller and conveyor if conveyor option fitted
GREEN BUTTON = Forward feed - push the button once - this activates the in-feed roller* and will
allow you to start shredding (if the drum speed is high enough).
BLUE BUTTON = Reverse feed - push the button continuously to back material out of the shredder. The
in-feed roller* will only turn in reverse as long as you keep pressing the button.
DELIVERY