TIMBERWOLF
TW SX200
21
SERVICE INSTRUCTIONS
All the hydraulic hoses should be regularly inspected for chafing and leaks. The hydraulic system is
pressurized to 110 Bar, the equipment containing it must be kept in good condition.
Identify the hoses that run to the top motor. These have the highest chance of damage as they are
constantly moving. If any hydraulic components are changed new seals should be installed during
reassembly. Fittings should then be retightened.
CHECK HOSES
ENGINE SERVICING
All engine servicing must be performed in accordance with the Engine Manufacturer’s Handbook
provided with the machine.
FAILURE TO ADHERE TO THIS MAY INVALIDATE WARRANTY AND/OR
SHORTEN ENGINE LIFE.
SERVICING THE CONVEYOR
1.
To tension the conveyor belt slackon nut (A) approx. 3mm on both sides.
2.
Tighten nut (B) up to the bracket on both sides keeping rear roller aligned correctly across
base tray.
3.
Take care not to over-tension conveyor, tension should be set to remove most of the slack and
allow the slats to run smoothly in guides.
Remove panel (C) when needing access to the end of the conveyor, i.e. for removing any jammed items
or accumulation of debris.
NOTE: NEVER RUN THE MACHINE WITH PANEL (C) REMOVED.
WARNING
Ensure the engine is switched off before working on the conveyor.
A
B
C
Summary of Contents for TW SX200
Page 28: ...TIMBERWOLF TW SX200 27 IDENTIFICATION PLATE EXAMPLE...
Page 36: ...Blank page...
