Timberwolf TW SX200, Manual

Page: 18 / 57

TIMBERWOLF
TW SX200
17
ALWAYS IMMOBILISE THE ENGINE BEFORE UNDERTAKING ANY MAINTENANCE WORK ON
THE SHREDDER BY REMOVING THE KEY AND DISCONNECTING THE BATTERY.
1. Remove the negative lead first and then the positive lead.
2. Clean, charge and/or top up the battery as required.
3. Refitting is the reverse of removal. Apply a smear of vaseline to the terminals to prevent
corrosion.
Size Pitch Head Torque Ibft Torque Nm
Roller Support Bearing M10 Standard 8mm Allen Key 20 27
Drum Housing Clamp Nuts M16 Standard 24 mm Hex 40 54
Hyd Motor Retaining Cap Screws M12 Standard 10 mm Allen Key 60 81
Roller Box Retaining Bolts M16 Standard 24 mm Hex 105 140
Rotor Shaft Retaining Screws M12 Standard 10 mm Allen Key 105 140
Funnel Retaining Nuts M12 Standard 19 mm Hex 60 80
General M8 Standard 13 mm Hex 17 23
General M10 Standard 17 mm Hex 34 46
General M12 Standard 19 mm Hex 60 80
The lifting eye is designed to lift the machine’s weight only. Do not
use hoist hook directly on the lifting eye, use a correctly rated safety
shackle. Inspect the lifting eye prior to each use - DO NOT USE
LIFTING EyE IF DAMAGED.
SAFE MAINTENANCE
SAFE LIFTING OF THE SHREDDER
WARNING
Refer to the battery safety section on pages 18-19.
SPARES
Timberwolf TW SX200 models are subject to large vibrations during the normal course of operation.
Consequently there is always a possibility that nuts and bolts will work themselves loose. It is
important that periodic checks are made to ensure the security of all fasteners. Fasteners should be
tightened using a torque wrench to the required torque (see below). Uncalibrated torque wrenches
can be inaccurate by as much as 25%. It is therefore essential that a calibrated torque wrench
is used to achieve the tightening torques listed below.
SERVICE INSTRUCTIONS
HANDLE hammers with extreme caution
to avoid injury. Gloves should always be
worn when handling the hammers.
THE drive belts should be connected
while changing hammers, as this will
restrict sudden movement of the drum.
THE major components of this machine
are heavy. Lifting equipment must be
used for disassembly.
CLEAN machines are safer and easier to
service.
AvOID contact with hydraulic oil and fuel.
Only fit genuine Timberwolf replacement screws and shredder spares. Failure to do so will
result in the invalidation of the warranty and may result in damage to the shredder, personal
injury or even loss of life.
BATTERY REMOVAL AND MAINTENANCE
CHECK FITTINGS