IM2021
28
2. Heating power mode selection
2.1. Press the “1” button to select low heating power, the indicator light of “1” button will
light during heating.
2.2. Press the “2” button to select medium heating power, the indicator light of “2”
button will light during heating.
2.2. Press both "1" and "2" buttons to select high heating power, the indicators of both
buttons will light during heating.
3. Temperature setting
Turn the thermostat handle fully clockwise, and if the room temperature is lower than
the set temperature, the indicator lights on the switch will light up. When the room
temperature reaches the set level, turn the thermostat handle counterclockwise until
the appliance turns off, the indicator lights on the switch will go out. Now the thermostat
will maintain the set temperature, periodically turning the convector on and off.
In exceptionally cold weather, the convector may not fully get the heating temperature
you need. In this case, set the thermostat handle to a level slightly higher than you
normally need.
4. Turning OFF
Set the switch buttons to the “0” position and disconnect the device from the mains.
NOTE:
When turning on the convector for the first time, a smell of burning and smoke may
appear. It happens because of burning of preservative grease on the heating element.
It is recommended to turn on the convector for the first time in a well-ventilated area.
9.
CLEANING AND MAINTENANCE OF THE UNIT
The external body of the device must be regularly cleaned from dust and dirt, because
this affects the efficiency of its work.
Before cleaning, turn off the device and unplug it from the network, let it cool, then wipe
its body with a soft, slightly damp cloth. Then wipe it dry and allow the device to dry
completely. It is not recommended to use detergents, including detergents with
abrasive compounds to clean the body of the device. Do not damage the appliance
with sharp objects, because scratches on paint can cause rust.
The rear side of the convector must also be periodically cleaned from dust and dirt. To
do this, disconnect the device from the brackets, and after cleaning, put it back on the
brackets.
Cleaning should be carried out periodically to maintain the technical condition of the
convector and preserve its appearance for many years.
Summary of Contents for TEC.E1X M 1000
