Timberk TEC.E1X M 1000, Instruction Manual

Page: 23 / 60

IM2021
23
7. ASSEMBLY AND INSTALLATION
Wall installation of the device
1. Open the packaging and carefully remove the appliance and wall-mounting kit
from it.
2. Remove any foam seals on the edges of the device and release it from plastic
bag.
Fig. 3
The dimensions are in mm
3. According to Fig. 3 choose the location for the installation of the device in
compliance with the minimal distances from other objects and floor.
4. According to the distances shown in Fig. 4, mark the location of the brackets
on the wall. Drill holes (drill diameter 6 mm), insert dowels (not supplied), fix
the brackets to the wall with screws.
5. Turn the device over, fasten the fasteners with the screwdriver and screws to
the bottom of the device on the left and right sides (Fig. 5).
6. Place the convector on the brackets. Put the markings on the wall through the
holes of the fasteners (see step 5), and then remove the device from the
brackets. Drill holes (drill diameter 6 mm), insert dowels (not included in the
delivery set (Fig. 6)).
7. Place the device on the wall, hanging it on the brackets and fixing it with
screws through the fasteners in the lower part of the device (Fig. 7).