Tili MPM3-12HRN1-BH9, Owner'S Manual

Page: 8 / 19

OPERATING INSTRUCTIONS
7
ION/PLASMA button(optional)
TURBO button
Used to set the strong fan speed, the set
temperature will reach in the shortest time.
This function is only availabe on COOL mode.
.
Press the this button, the anion generator/
Plasma Filter is energized and will help to
remove pollen and impurities from the air,
and trap them in the filter.
SLEEP button
Press this button, the selected temperature
will increase(cooling) or decrease(heating)
by 1
30 minutes.The temperature will
then increase(cooling) or decrease(heating)
by another
after an additional 30
minutes. This new temperature will be
maintained for 7 hours before it returns
to the originally selected temperature. This
ends the Sleep mode and the unit will
continue to operate as originally program-
med. The Sleep mode program can be
cancelled at any time during operation by
again pressing the SLEEP button,or turning
off the unit, or pressing the MODE or FAN
button.
This feature is unavailabe under
FAN or DRY mode.
NOTE:
O O
O O
C/2 F
C/2 F
1
Shows the set temperature in C
" " " "
or F
and the Auto-timer settings.
Room temperature sensor error-
Unplug the unit and plug it back in. If
error repeats, call for service.
Evaporator temperature sensor error-
Unplug the unit and plug it back in. If
error repeats, call for service.
Conenser temperature sensor error-
Unplug the unit and plug it back in. If
error repeats, call for service.
Bottom tray is full - Remove the bottom
drain plug and drain off the water.
Error codes:
E1-
E2-
E3-
P1-
7
8
9
10
LED Display
11
To activate the Follow Me feature, point
the remote control towards the unit and
press the Follow Me button. T
If the unit does not receive the Follow
Me signal during any 7 minute interval,
the FOLLOW ME indicator light turns off
to indicate the mode has ended.
he remote
display is actual temperature at its
location. The remote control will send
this signal to the air conditioner every 3
minutes interval until press the Follow
Me button again.
This feature can be activated by
the remote control ONLY. The
remote control serves as a remote
thermostat allowing for the precise
temperature control at its location.
Follow me indicator light
(optional)
TIMER operation
When the air conditioner is on:
- Press the "TIMER " button will first activate
the Timer Off setting program. The TIMER
OFF indicator light illuminates and the
LED display window appears "0.0 " .
- Continue pressing or keep pressing the
"UP or DOWN " button to select the time
you need the unit to stop operation. If
press UP button, the time is programmed
as :0.0- 0.5-1.0-1.5-2.0-2.5-3.0-3.5-4.0-4.5
-5.0- 5.5-6.0-6.5-7.0-7.5-8.0-8.5-9.0-9.5-
10-11-12-13-14-15-16-17-18-19-20-21-22
-23-24-0.0. If press the DOWN button, the
time is programmed in reverse order.
- When the desired time is established,
wait for 5 seconds or press the TIMER
button again to register the time. The
setting temperature will immediately
revert back in the display window. And
the TIMER OFF indicator light remains
on indicating the program is set.
- If press the TIMER button once again,
the TIMER ON indicator light illuminates
and the LED display window appears
"0.0 ". You are ready to adjust the ON
Timer setting.