Tili MPM3-12HRN1-BH9, Owner'S Manual

Page: 10 / 19

OPERATING INSTRUCTIONS
9
6
Press the FAN button to select the desired fan
speed:
LOW MED HI AUTO
Fan Options:
COOL (4 speeds) Low-Med-Hi-Auto
DRY(1 speed) LOW
FAN (4 speeds) Low-Med-Hi-Auto
Low-Med-Hi-Auto HEAT(4 speeds)
AUTO (1 speeds) AUTO
FAN button
(No display)
TURBO/PUMP button
Used to set the strong fan speed, the set
temperature will reach in the shortest time.
This function is only availabe on COOL mode.
SLEEP button
Press this button, the indicator displayed
and the selected temperature will increase
(cooling) or decrease(heating) by 1
in 30 minutes.The temperature will then
increase(cooling) or decrease(heating)
by another
after an additional 30
minutes. This new temperature will be
maintained for 7 hours before it returns
to the originally selected temperature. This
ends the Sleep mode and the unit will
continue to operate as originally program-
med. The Sleep mode program can be
cancelled at any time during operation by
again pressing the SLEEP button,or turning
off the unit, or pressing the MODE or FAN
button.
This feature is unavailabe under
FAN or DRY mode.
NOTE:
O O
O O
C/2 F
C/2 F
1
7
8
9
SWING button:
Allows the top horizontal louver blades to
oscillate forward and backward to the desired
direction. Each press will change the swing
angle for 6 . If keeping pressing the button
without releasing for 2 more seconds, the
louver blades would oscillate forward and
backward automatically.
O
Button functions on Control Panel
1
2
Press the MODE button to select the
appropriate operating mode:
AUTO COOL DRY FAN HEAT
Power switch on/off.
MODE button
ON/OFF button
auto
HEAT mode is for cooling & heating models only.
3
TIMERON/OFF button:
Used to initiate the start time/
stop time program , in
confuction with & buttons.
AUTO ON
AUTO OFF
Used to adjust (increasing/decreasing)
temperature settings(1 C/2 F increments)
in a range of 17 C(62 F) to 30 C(88 F).
Under Auto-timer setting, press or hold
the Up or Down button to change the
Auto time by 0.5 hour increments, up to
10 hours, then at one hour increments up
to 24 hours.
4
Temperature/Time Up/Down buttons
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press
and hold the Up and Down buttons at the same
time, for 3 seconds.
ION/PLASAM button(on some models)
Press this button, indicator displayed
indicating the anion generator/Plasma filter
is energized and will help to remove pollen
and impurities from the air, and trap them in
the filter.
5
10
To activate the Follow Me feature, point
the remote control towards the unit and
press the Follow Me button. T
If the unit does not receive the Follow Me
signal during any 7 minute interval, the
FOLLOW ME indicator disappeared to
indicate the mode has ended.
he remote
display is actual temperature at its location.
The remote control will send this signal to
the air conditioner every 3 minutes interval
until press the Follow Me button again.
This feature can be activated by the
remote control ONLY. The remote
control serves as a remote thermostat
allowing for the precise temperature
control at its location.
Follow me indicator( )
(on some models)