16
17
Installing the Mirage – Setup and Tuning
The Waterproof Remote Control
When the connections have been made as shown on pages 9 to 15
it is time to close the Mirage and secure the mirror frame.
It may be necessary to adjust the position of the cables in order to
close the mirror frame easily.
Apply light pressure to the left hand side of the mirror and insert one
of the screws through a fixing point and into the wall frame. To ease
hole alignment it may be necessary to remove the black caps from
the fixing points and loosen the screws. There is no need to fully
tighten the screw at this stage.
Switch the mains supply on and the Mirage should show a red
indicator light showing that it is in standby mode. The touch sensitive
controls need time to adjust their sensitivity to match their
environment – they should not be touched for 30 seconds.
Initial Tuning
Press the
POWER
(
) button on the remote control to switch the
Mirage on from standby. After a few seconds the
NEW INSTALLATION
menu will be displayed.
The on-screen menus can be in any of the following nine languages:
English, Español, Françes, Italiano, Nederlands, Polski, Portugês,
Pycc
кий
, and Deutsch.
1
Press the
LR
buttons to select the required menu language.
2
Press the
D
button once to select
Auto Tuning
and press the
R
button to enter the Country selection window.
NEW INSTALLATION
Language English
Auto Tuning
EXIT
MENU
OK
OK
EPG
MENU
EXIT
EPG
MENU
16:9
AUDIO
☛
If a Sky™ box is being used as a source it should
be switched on before tuning the Mirage. This
will allow the Mirage to tune to the Sky™ box
correctly.
Before the waterproof remote control can be used the insulating plastic film must be removed from
beneath the battery.
Place the remote
control face down on
a horizontal flat
surface and use
the opener to
release the battery
cover by rotating it in an
anti-clockwise direction. Set
the battery cover and opener to
one side.
Rest one finger lightly on the battery and pull the
printed tag to ease the insulating film from underneath
the battery. Try to avoid touching the black O-ring as it is
coated in light grease.
Replace the battery cover and lock it back in place using the opener.
LiThium Cell
CR2032
3V
LiThium Cell
CR2032
3V
Remote control
with battery cover
removed.
Whenever the Mirage is reconnected to the mains supply the touch sensitive controls need time to
adjust their sensitivity to match their environment – they should not be touched for 30 seconds.
