TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-7000 Installation & Operating Instructions
TiL 05RE375 Rev n/c Issue 13
2-12
Boot Speed
- When set to quick, some boot up messages will be skipped. When set to
normal, all messages will be displayed.
Panel Lighting
– Select 28 volts AC/DC or 5 volts AC/DC. No damage will occur if the
wrong setting is made.
F1-F4 Keys
– If set to normal, the keys will emulate the side buttons on the portable. If set
to channels, the keys become quick channel load keys. The channels can be programmed in
the second function menu.
Sidetone 1 Level
– Sets the sidetone level for band 1. The microphone and headphone audio
becomes live while in this mode to facilitate setting to a comfortable level. The factory
setting is 11.
Sidetone 2 Level
– Sets the sidetone level for band 2. The microphone and headphone audio
becomes live while in this mode to facilitate setting to a comfortable level. The factory
setting is 11.
Sidetone 3 Level
– Sets the sidetone level for band 3. The microphone and headphone audio
becomes live while in this mode to facilitate setting to a comfortable level. The factory
setting is 11.
Sidetone 4 Level
– Sets the sidetone level for band 4. The microphone and headphone audio
becomes live while in this mode to facilitate setting to a comfortable level. The factory
setting is 11.
2.18 KEYLOADING
MODE
If the TDFM 7000 is equipped with hardware encryption, then the Encryption keys will need
to be loaded using a
Motorola KVL 3000+®
Keyloader.
Keyloading must be done by putting the transceiver into flash upgrade mode by turning on
the radio while holding the HOME key. Select the band to be keyed-loaded by pressing the
BAND key. Press the RESET Key to reset the modules and to put them into keyload mode.
Wait until the display returns to the “Flash Upgrade mode” Power up the keyloader and plug
the cable into the 7000 Program port. Follow the Motorola Keyloader instructions for
uploading the actual keys to the radio.
If other bands require keys, press the BAND key to select the next module, wait 1 second
for the keyloader to since to that module, then upload the key(s).
When keyloading is done, remove the keyloader cable and press the EXIT key to reboot the
transceiver back to normal operation
2.19 FLASH UPGRADE MODE
On occasion it may be required to flash upgrade one or more of the modules in the radio to
change or add new features. This can be done using the Motorola RIB box and/or software
supplied in a Motorola flash upgrade kit. The transceiver must be put into flash upgrade
mode by turning on the radio while holding the HOME key. Select the band to be upgraded
by pressing the band key. Follow the software instructions. During the flash procedure, the
software will ask you to turn off and on the radio, use the RESET soft-key, do not turn off
the transceiver.
Summary of Contents for TDFM-7000
Page 56: ......
