TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TDFM-7000 Installation & Operating Instructions
TiL 05RE375 Rev n/c Issue 13
2-8
Programming Cables for units with Type I modules
To make any changes to the programming in the radio, CPS™ software must be used. There
is no provision in the Type I radio to allow the user to change frequencies, zones, talk
groups, etc. from the front panel.
“ASTRO Saber & XTS 3000”CPS™ software can be purchased from Motorola Customer
Service (see following page). A Motorola Radio Interface Box (RIB) is required to connect
the computer to the TDFM-7000 if Type I modules are installed. Each band in the TDFM-
7000 is considered a Type I (XTS-3000) portable by the CPS™ software. To program a band
in the transceiver, it must be selected by pressing the BAND key before running the CPS™.
Follow the instructions supplied with the CPS™ and RIB. The radio cable supplied with the
RIB will not connect to the TDFM-7000, therefore you will need to purchase the Type I
programming cable, P/N 037347-1.
The CPS Programming software must be purchased from Motorola on Line (MOL).
For instructions on ordering Motorola parts and CPS software see TIB TIBFM 12-01 REV E.
This document can be found in Appendix A or is available on the Technisonic Web site at
www.til.ca.
Follow the link for TDFM 7000 and click in the Link for “CPS Programming software/Cables
ordering Guide”. Refer to the section for Type I Modules.
P/N RVN4182
CPS Programming Software,
Note:
Latest revision will be provided.
P/N RLN10150
Smart RIB Interface Box
P/N 0180202E27
Smart RIB AC PWR PAC 110V
P/N 3080390B48
Computer RIB Cable
The XTS-3000 and XTS-5000 are products of Motorola, Inc.
The KVL-3000 is a product of Motorola, Inc.
A Technisonic Type I programming cable P/N037347-1 is also required and available from
Technisonic. If encryption keys need to be loaded via a KVL-3000+, keyloader cable P/N
037348-1 may be also be obtained from Technisonic. This keyloader cable will plug into the
front connector of the TDFM-7000 transceiver and will work with Type I or Type II modules.
To use the programming connector on the front of the TDFM-7000 transceiver, which is
preferable when the unit is installed in an aircraft, use the following:
P/N 037347-1
Download/Programming Cable that mates with RIB interface Box to
program TDFM-7000 units employing Type I modules.
P/N
037348-1 Encryption Keyload Cable that mates with Motorola KVL-3000
Keyloader. Same P/N for Type I or Type II modules.
P/N 013524-1
Alternate programming cable that mates with Rear DB 25 connector.
Summary of Contents for TDFM-7000
Page 56: ......
