Tiger TRIPLE FLAIL JD5 M T4F Series, Mounting And Operating Instructions

Page: 32 / 240

ASSEMBLY
Assembly Section 2-2
Before attempting to mount your Tiger mower, it is important
to read and understand all of the safety messages in the Safety
Section of this manual.
Check complete shipment list against the packing list to make sure there are no
shortages. Make certain the tractor model is the appropriate one for the mower received!
Always use a floor jack, hoist or fork lift to lift and raise heavy parts.
Read and understand the entire Assembly Section instructions before attempting to mount
your Tiger mower. Refer to the Parts Section of this manual for detailed illustrations to locate all
parts.
(ASM-C-0001)
TRACTOR PREPARATION
A. Remove right and left hand steps.
B. Disconnect battery cables from both batteries.
C. Remove engine side panels, or raise hood to access front pulley.
D. Remove plugs from tractor casting where mainframe and pump mount will be attached.
E. Remove any front weights and weight supports.
F. Raise the tractor onto jack-stands and remove the right and left rear wheels.
(ASM-JD-0001)
ADJUSTING REAR WHEELS
Raise rear of tractor onto jack-stands. Follow the instructions in the tractor owner’s
manual for adjusting tires and rims . The back wheels MUST be adjusted to the widest
setting. NOTE: This may require switching the wheels to opposite sides of tractor. Also take
note of any width restrictions when transporting by trailer. (For ease of installation, it is best to
leave the rear wheels removed during installation of the mower.)
(ASM-B-0001)