CD42CD/CD48CD
Setup Instructions
For Serial Nos. 850,000 & Higher
Loose Parts
Use the chart below to verify that all parts have been shipped. Part numbers not shown are available on the dealer
extranet.
Dealer Pack
Part #
Description
Qty.
Use
—
Warranty Registration Reminder
Fill out the online warranty registration
form.
Literature Pack
Part #
Description
Qty.
Use
—
Manual, Operator’s
1
—
Manual, Parts
1
Read before operating the machine.
WARNING
Operating a Navigator tractor without an
approved Exmark front mount attachment
increases the possibility of operator
entanglement in drive wheels or forward tip
over. Entanglement or tip-over could cause
serious injury or death.
When operating a Navigator tractor without
an approved Exmark front mount attachment,
observe the following:
•
Keep feet and clothing away from tires.
•
Limit operation to minimum required to
install a different front mount attachment.
•
Minimize speed and use extreme caution.
•
Only operate on a flat level surface.
•
Do Not operate up or down a trailer ramp.
•
Avoid sudden acceleration or deceleration.
Uncrating the Unit
1.
Remove top and sides of crate from base.
2.
Remove flat hairpins from under front frame and
discard (Figure 1).
Assembling the Discharge Chute
1. Locate the three holes at the rear of the mower deck
shown in (Figure 1) and remove the three #10-24 x
3/4 inch truss head screws and three #10-24 inch
nyloc nuts.
2. Assemble the discharge tube to the mower deck as
shown using the hardware removed in step 1, with
the hinge positioned on top of mower deck.
3. Locate the discharge tube spring on the mower deck
and hook onto the discharge tube spring bracket
(Figure 1).
© 2009—Exmark Mfg. Co., Inc.
P.O. Box 808
Beatrice, NE 68310
Part No. 4500-597 Rev. A
Printed in the USA
All Rights Reserved
