Tiger NEW HOLLAND T6000, Mounting And Operating Instructions

Page: 52 / 280

ASSEMBLY
Assembly Section 2-20
LIFT VALVE HOSE & CABLE ROUTING
Attach two clamps to the right rear wheel well for proper hose/cable routing. Drill one hole for
each clamp. Use the lower rear corner of the wheel well as an origin for measuring. The holes
should be Ø10mm or Ø3/8” reamed to accept 3/8” hardware.
Measure from the back edge of the wheel well 13-1/2” from the origin. Use a square to
measure 3-1/2” up. Refer to the images below to see the first hole placement.
The second hole should run parallel to the bottom edge of the wheel well. Mark the hole 12”
from the first hole and 3-1/2” from the bottom edge. Use the images below for reference.
NOTE: DO NOT CUT INTO TUBES / HOSES / WIRES WHEN DRILLING THROUGH METAL
OR PLASTIC!
Place as many hoses in the clamp that will fit without compromising pressure. Then secure
the (2) HOSE CLAMP (06520013) to the holes drilled with (1 EACH) CAPSCREW,3/8” X 1”,NC
(21630) and (1 EACH) NYLOCK NUT,3/8”,NC (21627). The hoses that don’t fit into the clamp
are to be secured to the others with zip-ties. For protection of hoses in contact with metal edges,
wrap hoses with split hose sections and fasten with hose clamps or zip-ties as needed.
(ASM-NH-0067)
JOYSTICK STAND MOUNT
Mount the Joystick Stand Mount in the same position as the Cable Control Lever Stand.
Place the front edge of the support bracket 2-3/4” back from the lower right front window. Rotate
stand to be 2-1/4” from the right door frame as shown below. Be sure that the location of the
stand will allow clearance between the cable control handles and all existing interior levers, etc.
Drill 3 holes to match control bracket and secure with capscrews and nylock nuts noted in the
Parts Section.
Cut a 2-1/4” hole in the door from inside the cab. This hole is to be located 2-1/2” away from
the floor, and 4” from the metal edge by the right door. Install trim lock around the metal edges of
the then route the cables through the hole. Next, wrap the cables with the 6” split hose at the
point they pass through the hole, and secure with zip-ties.
(ASM-NH-0059)