Tiger NEW HOLLAND T6000, Mounting And Operating Instructions

Page: 36 / 280

ASSEMBLY
Assembly Section 2-4
POLYCARBONATE SAFETY WINDOW
NOTE: Installing a boom mower requires that all of the right side windows be replaced,
or protected with a polycarbonate window. This should be done before mounting the main
frame.
1. Disconnect gas shock at door. Remove the right side cab door/window glass from tractor
cab by removing hinge pins. Also, remove rear right side window.
2. Remove the existing hardware and discard factory glass door and window.
3. Place small bead of adhesive seal in the bottom of the trim lock bubble seal.
4. Install trim lock bubble seal on polycarbonate starting at the center bottom horizontal
portion.
5. Install existing hardware removed from glass door and window on the polycarbonate.
6. Install the polycarbonate assembly in the cab with existing and supplied hardware.
7. Press polycarbonate into place at upper front corner
8. Drill a Ø3/16” pilot hole through polycarbonate and corner gusset of door jam.
9. Locate hole 1-1/4” from edge of the lower rounded feature of the corner gusset and center
it from each end. Then drill out hole in polycarbonate with a Ø15/32” bit that is
only used for
polycarbonate.
10. Drill out hole in gusset with Ø3/8” bit for steel.
11. Install the polycarbonate door into place where factory door wsa removed (upper right
rear first). Refer to the parts section for the details.
12. Install grommet into hole in polycarbonate. Install supplied 1/4” nut into corner gusset.
13. Secure upper right corner with supplied washer and capscrew. Refer to the Parts
Section for details.
(ASM-NH-0052)