Tiger NEW HOLLAND T6000, Mounting And Operating Instructions

Page: 110 / 280

MAINTENANCE
Saber Maintenance Section 4-2
©2011 Alamo Group Inc.
MAINTENANCE
General Instructions
Tiger Mowers are designed for high performance and rugged durability, yet with simplified maintenance. The
purpose of this section of the manual is to help the operator in the regular servicing of the mower. Regular
maintenance at the intervals mentioned will result in the maximum efficiency and long life of the Tiger Mower.
When you purchase a Tiger Mower you also acquire another valuable asset, Tiger’s parts organization. Our
rapid and efficient service has guaranteed the customer satisfaction for many years. Tiger parts keep up with
the demands for efficiency, safety and endurance expected of the Tiger Mower.
Maintenance Precautions
• Be sure end of grease gun and zerks are clean before using. Debris injected into bearings, etc. with grease
will cause immediate damage.
• DO NOT use a power grease gun to lubricate bearings. These require very small and exact amounts of
lubrication. Refer to the detailed maintenance section for specific lubrication instructions. DO NOT over-
grease bearings.
• Lexan windows should be washed with mild soap or detergent and luke warm water, using a soft clean
sponge or soft cloth. DO NOT use abrasive or alkaline cleaners or metal scrapers on lexan windows!
• Be alert to maintenance indicators such as the in-tank filter pressure gauge, hydraulic reservoir sight
gauge, etc. Take the required action to correct any problems immediately.
• Release of energy from pressurized systems may cause inadvertent actuation of cylinders, or sudden
release of compressed springs. Before disconnecting any hoses relieve pressure by shutting tractor off,
setting cutter on ground and actuating lift valve handles.
Break in Period
In addition to following the break in instructions for your particular tractor, the in-tank hydraulic fluid filter should
be replaced after the first 50 hours of service. Thereafter the filter should be replaced every 500 hours, or
yearly, which ever comes first.
Re-torque wheel lugs after first five hours of operation and periodically thereafter. See torque specifications
listed in the tractor’s service manual for your particular model.
Wheel lugs must always be re-torqued
whenever a wheel is removed and reinstalled.
Do not operate this Equipment with hydraulic oil or fuel leaking. Oil
and fuel are explosive and their presence could present a hazard. Do
not check for leaks with your hand! High-pressure oil streams from
breaks in the line could penetrate the skin and cause tissue damage
including gangrene. To check for a hose leak, SHUT the unit ENGINE
OFF and remove all hydraulic pressure. Wear oil impenetrable gloves,
safety glasses and use Cardboard to check for evidence of oil leaks. If
you suspect a leak, REMOVE the HOSE and have it tested at a Dealer.
If oil does penetrate the skin, have the injury treated immediately by a
physician knowledgeable and skilled in this procedure.
(SG-15)