Tiger M6-131, Mounting And Operating Instructions

Page: 35 / 226

ASSEMBLY
Assembly Section 2-5
POLYCARBONATE SAFETY WINDOW
NOTE: Installing a boom mower requires that all of the right side windows be replaced with
polycarbonate. Install the safety windows after all of the cab wiring and mounting is done; and
before the boom arm is mounted. Locate all the hardware in the Parts Section when installing
the polycarbonate.
Remove the right door from the tractor cab. Remove the hardware and check the image
below for which parts are re-used. Wrap the trim seal around the polycarbonate and cut the
trim to match the other end so a seal will form to the frame. Apply the adhesive in the groove
of the trim seal where the polycarbonate sits and apply the trim seal to the polycarbonate. Add
the hinges (with existing hardware), door handle (with supplied hardware) and the handrails
(with existing hardware) and install the polycarbonate to the tractor frame.
Close the polycarbonate door to the cab. Remove the handrail and install the two handrail
brackets between the tractor and the handrail. Reattach the handrail.
Drill a 1/4” hole in the center of the bottom door frame. Attach the bottom bracket as shown
in the Parts Section. Use the vibration isolator, threaded rod and hex nuts to push the
polycarbonate against the frame.
Remove the mirror hardware and install the mirror bracket on the bottom two holes of the
tractor mirror mount with the hardware provided. Use the vibration isolator, threaded rod and
hex nuts to push the polycarbonate against the frame.
Locate the existing hole over the fender in the door frame of the cab. Attach the
polycarbonate backet to the fender with the hardware provided. Drill a 5/16” hole through the
polycarbonate and secure the window to the mount. To attach the lower rubber washers to the
poltcarbonate, drill a 5/16” hole through the polycarbonate so the inner washer presses on the
door frame and is 1” away from the edge of the door.
(ASM-KUB-0033)