Tiger M6-131, Mounting And Operating Instructions

Page: 39 / 226

ASSEMBLY
Assembly Section 2-9
VALVE MOUNTING
The valve mounting bracket is fastened above the rear remotes. The slots closest to
the remotes use the existing hardware. The existing hardware is to be loosened until the
bracket can slide under the hardware. Next, align the holes of the bracket to the holes in
the tractor. Secure the bracket to the tractor with the hardware provided. Re-tighten the
existing hardware. See the Parts Section for additional reference.
Next, attach the valve mounting plate to the mounting bracket. Align the holes on the plate to
the holes on the bracket. Use the hardware shown in the Parts Section to attach the plate to the
valve mounting bracket. Finally, place the valve on the valve mounting plate as shown in the
Parts Section. Align the holes on the valve assembly to the holes on the plate. Use the hard-
ware provided to secure the valve to the plate. Refer to the Parts Section for the placement of
the valve and the hardware used.
Please handle the lift valve with care. It is extremely
heavy and contains small parts.
(ASM-KUB-0006)
JOYSTICK CONTROL MOUNTING BRACKET
Preassemble the joystick mounting as shown in the Parts Section. Use the image below for
positioning the joystick control bracket. Position the support bracket on the floor as a tem-
plate. The upper left hole of the bracket is 7-1/8” from the edge of the door and 6-3/4” from the
corner post as shown below. The front corner of the bracket is 2-3/4” from the edge of the door
as shown below. Mark the holes on top of the floor mat. Be sure that the location of the stand
will allow clearance between the joystick and all existing interior levers, etc. Also watch out for
wiring and brackets when placing the bracket for drilling and cutting. Cut holes in the mat with a
1-1/8” hole saw. The spacers provided are used to allow the control bracket to set on top of the
floor mat while being held securely to the floor of the cab. Drill 3 holes for the capscrews using
the bracket and spacers as a template. Then secure with the hardware as noted in the Parts
Section.
(ASM-KUB-0032)