TIFFIN MOTORHOMES
–PHAETON®
Chapter 13
ROUTINE MAINTENANCE
13-30
To connect the cleaning hose, raise the wall remote inlet valve door, (Figure 13-9) and align hose end coupling with
slots on each side of intake opening. Firmly push into intake opening. Make sure hose end coupling is connected and is
locked in place. To disconnect the hose, simply push in the slots on each side of the hose coupling and pull hose end
straight out.
NOTE: The vacuum cleaner hose must be plugged into the outlet to activate vacuum motor.
To start the vacuum cleaner:
1. Push the on/off switch on the main vacuum to the “on” position. Indicator light in switch will come on.
Now the vacuum will come on and off by using the wall remote inlet valve.
2. To turn on, raise the door up.
3. To turn off, lower the inlet valve door down and the vacuum will turn off. The main vacuum on/off switch should
stay in the “on” position all the time, except when traveling.
4. To turn completely off, return main vacuum on/off switch to the “off” position. The switch light will go off.
To change the dust bag you will need to open the door on the vacuum cleaner by pushing the latch upward and
remove the door completely. Remove the full bag and discard. Next, locate the pipe inside the vacuum chamber.
Holding the new bag’s cardboard collar at approximately a 45º degree angle, insert the cardboard part of the bag
against the upper back of the vacuum cleaner chamber behind the pipe. Lift the front of the collar over the pipe as far
as possible. When closing the door, tuck in the left and right corners of the bag, so the door is properly sealed and the
latch clicks into place.
The vacuum cleaning system comes with an array of attachments that can be connected to the hose ends for extensive
cleaning purposes. Make sure they are firmly pushed in and twist to hold in place.
For further instructions to change the dust bag, use the attachments, and proper cleaning technique, refer to the
specific Owner’s Manual located in your motor home.
Warning
This appliance has a THERMAL PROTECTOR built in the motor to prevent
overheating. If motor will not operate or shuts down while in operation wait 30
minutes; it will reset automatically. Turn unit off while it resets. If the motor does
not come on, or Thermal Protector trips off again after a short period, service may
be needed. A qualified service technician should perform service.
Summary of Contents for 2014 Phaeton
