Tiffen Steadicam M-2, System Manual, Page: 37 / 54

37
T
he M-2 monitor mount is intended to allow practically limitless mounting positions. The monitor can be
positioned close to the post or far away. The mount can attach to either post. The monitor can be tilted
to any angle and arched from upright to inverted. Many of the possibilities take mere seconds to achieve
and none take more than a minute. Get creative and put that monitor where it helps you most!
To move the monitor fore and
aft on the rods, loosen the clamp
levers and slide. Re-lock clamp
levers to secure the monitor rods.
For fine angle adjustment, perhaps
to reduce glare, just tilt the
monitor by hand. No fasteners
required.
To pivot the monitor in an arc,
loosen the pivot clamp knob
and rotate the yoke around the
monitor pivot.
To move the mount on the post,
support the monitor and flip open
the clamp lever.
Slide to the desired height, and
align the mark on the post clamp
with the reference line to ensure
the monitor is square to the rig.
Lock the clamp lever to secure the
monitor mount in place.
Monitor mount positioning