Oven Chips
15-20
180-200
High
Pizza
10-12
180-200
High
Vegetables
12-15
180-200
Low
Dessert/Pastries
15-30
150-180
Low
CARE & CLEANING
CLEANING THE OVEN:
•
Always make sure that the oven is unplugged before cleaning.
•
Always allow the glass bowl, extension ring and/or lid to cool down before cleaning.
•
Never wash the glass bowl or the lid immediately after use.
•
Never immerse the top section (top lid cover) in water.
•
Be careful not to allow water or other liquids to get inside the top section (top lid cover) of the oven
when cleaning.
•
Never use solvents, abrasives cleaning powders, or metal or plastic scouring pads on the top lid
cover.
•
Cleaning your convection oven is easy; in fact your oven was designed to be easily cleaned. In
many cases, you can prepare & serve your whole meal in your convection oven. That means less to
clean.
•
Cleaning the glass bowl itself is also easy to do. Clean with a sponge or plastic scouring pad. If the
sides of the bowl are dirt, spray with glass cleaner. Add enough water to reach 25-35mm up the
sides of the bowl, and then add mild detergent. Put the lid on the bowl, set the timer for 10 minutes
and the thermostat to 100°C. The convection oven will clean, loosen and remove food particles. If
the bowl is very dirty, you may need to give it additional 2-3 minutes. Once this is finished, scrub the
inside of the bowl, then drain and rinse.
•
If the glass bowl is not very dirty, clean it by spraying with glass cleaner and then wiping it with a
warm, damp sponge. Rinse and dry the bowl.
•
The wire racks are coated, so they are easy to clean.
•
You can face the racks in the cooker upside down and then watch as the amazing self-cleaning
action softens and removes the residual grease.
CLEANING THE LID:
To clean the lid, spray the glass portion with glass cleaner. Scrub it with a plastic scouring pad, if needed,
then wipe clean with a warm, damp sponge. Wipe dry.
To clean the plastic portion of the lid, wipe with a warm damp sponge and dry. Do not use solvents or
abrasive cleaning powders on the plastic housing. Also, do not scrub it with metal or plastic souring pads.
WARNING: NEVER IMMERSE THE TOP COVER LID (TOP UNIT) IN WATER.
