Tieline Commander TLF200, Operation Manual, Page: 27 / 53

COMMANDER DETAILED CONFIGURATION
©
Tieline Technology
- 27 - August 2002
Sub Menus of 03 – Modem setup
01 POTS
AutoAnswer Yes (Enable)
COMMANDER automatically answers incoming calls
and starts operation.
Note:
You can use this with Auto redial to maintain a
program link over extended periods. COMMANDER
will automatically restore the link in a few seconds if a
“dropped call” occurs.
Disable COMMANDER will not automatically answer incoming
calls.
02 Auto Reneg 1 Disable
Setting for live program links. Prevents modem
renegotiation if line conditions change.
Note:
Use of auto-renegotiation can cause unexpected
program breaks with changes in line conditions.
2 Up Only Uses higher bit rate if LQ at both ends above 80%.
3 Down Only Lower bit rate used if LQ falls below 10% at either end.
4 Up & Down Auto renegotiation as line conditions vary.
03 Max Bit rate 33600
Bit Rate varies
with Menu
Selector
Sets the maximum bit rate at which the COMMANDER
will attempt a connection. Reducing this value can
improve reliability on poor quality lines.
04 Modem
Monitor Yes
(Enable) Enables the modem dialing and connection process to
be heard through the headphones.
Disable Disables the modem dialing and connection process to
be heard through the headphones.
05 Negotiate
Methd V8
Normally V8 (cancel Telco echo suppression). Don’t
alter this setting if making any long distance calls!
V34 This mode can be used to reduce connection time on
short distance calls.
Note:
Both Units have to be set to this mode for a
connection to work.
06 Exit to Setup