Tieline Commander TLF200, Operation Manual, Page: 22 / 53

COMMANDER DETAILED CONFIGURATION
©
Tieline Technology
- 22 - August 2002
Sub Menus of 01 – View Configuration
The View Configuration menu contains the main control settings and operating modes. Some of the same
options are also available from other sub menus and selecting them from the View Configuration menu
takes you into the appropriate sub menu. This means that should you select CLEAR from the Key Pad you
will go back one screen in whichever menu the View Configuration has taken you to (see page
Error!
Bookmark not defined.
for a diagram of all menus).
NOTE:
Default settings in the following submenus are
italicized
and
underlined .
Op Mode
1
POTS
Use this mode to connect via a standard (POTS) telephone
line.
2 Leased Line
Mode For operation over leased 2 wire bi-directional lines. As the
COMMANDER modem requires a loop voltage source for
correct operation, an optional line interface unit is available
for use with dedicated 2 wire circuits where the loop voltage
is not present.
3 Telephone
Mode Use COMMANDER as an Emergency phone; You will need
to plug headphones into the headphone socket and a
microphone into the Mic/Line in socket. Dial the phone
number on the keypad and when finished press the
Enter/Dial
key. To finish the call, press the
Hang Up
key.
4 ISDN Mode Use this mode to connect via an ISDN line.
5 Cell Phone
Mode Use to connect a hands free cable from a mobile phone to
the cell phone socket. Dial the remote phone or hybrid using
the mobile keypad.
Note: Line quality using Cell Phone Mode is limited to 3Khz,
the mobile networks data rate.
Control Mode Local
Gain of both input channels is set by the two front panel
controls on the “local” COMMANDER.
Master A pair of COMMANDERs can be set up to allow the “master”
to control the input gain of the “slave.” The remote TIELINE
Codec has to have the control mode set to “slave.” Adjusting
the Input controls on the “master” varies the “slave” input
gain. Monitor the levels on the “slave” by setting the PPM to
“remote.”
See page 35 for more details.
Slave Set the remote unit to “slave” for control by the “master”
COMMANDER. Front panel controls are disabled.
Toolbox Input gain can be adjusted using the Toolbox application.
“Toolbox” mode can be selected on the COMMANDER or by
clicking on the “Setup for T-box” button in the application.
Front panel controls are disabled.
PPM Mode Send
The Peak Program Meter shows the level of the audio being
sent to the remote unit.
Return The Peak Program Meter shows the level of the incoming
audio from the remote codec.
POTS Codec Music
Provides the highest quality when bit rates are 24,000 and
above. The codec will operate from 9,600 to 33,600bps.
Speech Used for 16,800bps.