TCSG5416W Wireless Sounder Installation manual
Ver1.3 202102
YINGKOU
TI
A
N
C
HENG
FIRE
PROTE
C
TION
EQUIPMENT
C
O.,
LTD
3
Figure 1 Schematic diagram of the appearance of the alarm
4.2. working principle
When the sounder receives the start signal from the control panle, it will start the sound and light
alarm output;
When the sounder receives the stop signal from the control panel, it will stop the sound and light
alarm output;
When the sounder is in the starting state, after receiving the reset signal from the control panel, it
will stop the sound and light alarm output, and the sounder will be reset;
When the sounder battery is low, the sounder sends a battery undervoltage signal to the control
panel , and the yellow indicator light flashes.
5.Installation Method
5.1. Before installation, first check whether the shell is intact and whether the identification is complete.
5.2. The way the sounder is fixed:
When installing, use two screws to fix the base of the alarm on the 86 series (width 72mm, height
49mm, depth 47mm) embedded box, and then install the sounder, the installation hole distance is
60mm.
Figure 3 Installation hole distance
6.Test
Warning: Please make sure that the polarity of the battery is correct before proceeding.
6.1. The sounder will be tested every year after installation and during use.
6.2. Startup test: After the networking is successful, you can choose a sounder and make it meet the
startup conditions artificially (please turn off the fire alarm linkage function to avoid unnecessary
sounder linkage). After the test, power on again and notify the relevant management The department
restored the system to normal.
6.3. During the test, the unqualified alarm will be resolved according to "general failure and
maintenance" and "maintenance".
7.Use and operation
7.1. Network segment setting: Before the detector is connected to the network, the device network
