WAVEJET™ SL
MICROWAVE OVEN
COMPONENT MAINTENANCE MANUAL
WITH ILLUSTRATED PARTS LIST
25-30-51
Page 7006
August 15, 2003
(1) Attach fan (200) with cordset plug (205) connected to component
tray using four screws (210), flatwashers (215) and locknuts (220).
(2) Correctly orient shroud (180) onto fan(200) and attach by using two
screws (185), flatwashers (190) and locknuts (195).
(3) Attach four flatwashers (170) and locknuts (175).
(4) Position transformer/relay bracket (145) onto the component tray
(150) and attach four flatwashers (170) and locknuts (175) at rear
and screws (155), flatwashers (160) and locknuts (165) on the
bottom.
(5) Attach diode support (50) to transformer/relay bracket using screw
(55) and locknut (60). Connect HV diode (45). Fasten HV diode to
diode support with tyrap (65).
(6) Position capacitor clip (40) over capacitor (30) and attach capacitor
clip (40) to transformer/relay bracket using locknuts (35).
(7) Install transformer (70). NOTE: Pay close attention to make sure
the correct attaching screws are in the correct locations. Attach
transformer with screw (130), flatwasher (135) and locknuts (140).
Install flatwasher (115) and wire clamp (105) onto screw (110) and
fasten to transformer relay bracket with flawasher (120) and
locknut (125). Install two flathead screws (90), flatwashers (95)
and locknuts (100).
(8) Connect faston terminal (75). Connect wires.
(9) Attach relay (20) to relay socket (25) using locknut (p/o 25).
(10) Attach transformer (5) using flatwasher (10) and nut (15).