WING
19. Secure control horn on Flap I with 2x15mm machine
screw. Note the control horn should away from the edge
at least 8mm. The 8mm is to clear the rib located at the
center of both flaps.
20. Leave 0.5mm clearance between ribs and flap then
draw the hinge line. Next cut hinge slots to accommodate
the hinges on flaps.
21.Join two flaps then insert them to the wing in place.
Make sure there is no contact with each other then apply
CA at the hinge area. Move the flap again and make sure
it works smoothly.
22. Repeat the same procedure on the right wing. Link
two aileron servo wires with Y cord and plug to CH1 on
receiver. Plug the left flap to Ch6 and right flap to Ch7.
Refer to your radio manual and set up Flap.
1.Reset first.
2.Flap ATV 140% 140%
3.AUX1 ATV 140% 140%
4.Airbrake on Flap 100%
5.PMIX7 AUX1-AUX1
Position 1: 0%
Position 2: 0%
Position 3: 0%
Position 4: 45%
Position 5: 90%
6.Trim the two flaps at same throws by adjusting the trim
knob and pushrod if necessary.
23. Epoxy the dowels at wing root in place as shown.
24. Locate the plastic retract well; trim along the molded
line.
25. CA the retract well in place, trim the excess plastic
so it is level with the wing root.
26. Place the retract in place and drill 5/64"(2mm) holes
on the retract mount.
27. Locate the retract pushrod and ball end, thread the
ball end as shown. The Z-bent end to the center of the
ball end is about 218mm.
28. Insert the pushrod from wing root then connect to
retract. Note: The ball end with "Tiger" side should face
upside of wing.
11
10
LANDING GEAR
Here is the set up procedure if using FF9 :
