Thrane&Thrane Sailor 6081, Installation & User Manual

Page: 9 / 68

Chapter 1: Introduction
2 General description
SAILOR 6080 units. The connectors for DC power are placed at the same end of
the unit for easy mounting and installation. The connection between the
Power Supply unit(s) and the connector panel are protected against water
ingress by a protection cover. A cable relief bracket to secure heavy cables is
integrated in the wall-mount tray.
When mounted vertically the Power Supply Unit and Charger and the SAILOR
6080 Power Supply fulfill IP32 in areas with more than 42 V and IP22 in other
areas.
SAILOR 6080
The SAILOR 6080 Power Supply
can deliver 300 W output power
on average with a peak of 370 W
for a minimum of 2 minutes. It is
AC powered. The Power Supply
has an on/off switch. It is lit
when the power is turned on.
Battery charger
In case of AC power failure or overload a battery connected to the SAILOR 6081
Power Supply Unit and Charger delivers the required power seamlessly. Note
that output power has a higher priority than the charging current.
To load deeply discharged batteries (battery voltage lower than 23 V) the
Power Supply Unit and Charger has a pre-charge mode. Regular charging
starts as soon as the battery voltage is above 23 V. The maximum charging
current and the nominal battery voltage can be adjusted. For further details
see Customizing battery settings on page 33.
Note
If the charging voltage of the battery terminal is below 8 V the
charging process will not start.