9
ENGLISH
2.1) Preparation
The tool can be easily carried using either the main handle (12) or the shoulder strap attached
to the two rings (8).
The main operating positions are : hori-
zontal standing on its feet and vertical
standing on its battery. In addition to
the main handle (12) the lower handle
(6) allows a safer and more balanced
grip when using two hands to hold
the tool.
Before starting any work, check
the battery charge (Ref. to § 2.8) and recharge if
necessary, following the instructions in the battery charger user manual.
To replace the battery, grip the tool as illustrated in Figure;
press the release button (11) and push the battery downward
unlocking it. Insert a charged battery from the bottom by sli-
ding it into the guides until it locks.
The display shows the operational parameters of the tool; to
customise them proceed as described in § 2.7.
Depending on the compression to be performed, proceed as
described in § 4 or 5.
2.2) Die advancement
Press operating button (1) to activate the motor-pump and
advance the lower die.
To halt the advancement, release operating button and the
motor will cut out.
Make sure the dies are exactly positioned on the
desired crimp point otherwise re-open dies following
instructions as per § 2.4 and reposition the connector.
2.3) Compression
By keeping operating button (1) pressed, the motor con-
tinues to operate: the ram will gradually move forward
until the two dies touch.
The motor will stop automatically when the set pressure
has been reached.
To perform proper compression, press and hold the
operating button (1) until the motor stops automati-
cally.
11
Battery
6
12
8
8
1
