15
FR
ANÇ
AIS
To make a selected screen operational and appear at each start-up of the
tool, operate the touch button for at least 3 seconds; a continuous beep
will confi rm the setting.
The capacitive menu selection button may not work if touched using
objects or when wearing gloves, therefore always operate it using a bare fi nger.
7.2) SELECTION SCREENS:
control parameters that cannot be set as automatic upon start-up
of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights
(factory setting LED ON)
When the screen is dis-
played, touch the button
for at least 3 seconds to
deactivate or reactivate op-
eration of the LED Worklights
during tool use;
a continuous beep will confi rm
the setting.
Return to original factory settings / fi rmware version
When the ‘RESET’ screen is displayed, return the tool to its factory setting by operating the touch
button for at least 3 seconds; a beep will confi rm the setting.
The RESET screen also shows the fi rmware version of the circuit board.
7.3) WARNINGS:
these appear during operation and notify the operator of the status
of the tool:
LED
OFF
LED
ON
LED
OFF
3 SEC.
LED
ON
LOW BATTERY: replace the battery.
NOTE: when the battery Vage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools
down.
NO. OF CYCLES TO MAINTENANCE REACHED:
the tool continues to work however, it is recommended that it is sent to Cembre
for a complete overhaul (see § 9).
NOTE: this message, together with a beep, will reappear when the tool has been
idle for 30 seconds.
13001
3
BATTERY
Ï
Ð
Ï
Ð
BATTERY
Ï Ð
RESET
SW:S1J41405
3 SEC.
