© 2018 Thorlabs
8
LEDD1B
4. Connect the PSU to the main supply, switch it ‘ON’ (not KPS101).
5. Your T-Cube LED driver is now ready for use. Turn the unit on by turning the control knob
clockwise.
See chapter
of this manual, for a brief tutorial on operation of the unit.
2.3 Mounting Options
The T-Cube LED Driver is shipped with a base plate fitted, ready to be mounted to a bread-
board, optical table or similar surface.
If desired, the base plate can be removed and the unit can be stood on rubber feet - see Sec-
tion
.
For multiple cube systems, a USB controller hub (TCH002) is available - see Section
for further details. Full instructions on the fitting and use of the controller hub
are contained in the manual
ha0146 T-Cube Controller Hub
, shipped with the TCH002.
2.4 Removing the Baseplate
In order to fit the rubber feet (supplied) or the unit shall be connected to the USB controller hub,
the base plate must be removed. Remove the bolts securing the unit to the base plate using a
hexagon key. Retain the bolts for future use if the base plate is refitted.
1. Turn the unit upside down.
Fitting rubber feet
2. Remove the backing paper from the rubber feet (supplied) taking care not to touch the ex-
posed adhesive surface.
3. Position the feet as desired, then press and hold for a few seconds until the adhesive has
bonded.
4. The unit may now be used freestanding, sitting on its rubber feet.
9
8
6
