Portable Connector
Chapter 12: Appendix
Page 65
TTN169162-D02
3. Checking for operating system false identification:
The Windows operating system’s Device Manager can be used to verify successful installation and
activation of the CC6000 frame grabber hardware
. If successful, “Norland Products CC60XX” or “Lumenera
2.0 Camera” will be visible in the list of Imaging Devices (as shown below) after the CC6000 has been
attached to a computer via the USB cable
and “new hardware” installation has been completed. If the
CC6000 is a model that uses the Sentech camera, it will be listed in its own “Sentech Devices” section of
the Device Manager list (rather than under Imaging Devices). The Device Manager can be accessed as
follows:
a. Click START at lower left of the Windows desktop, right-click on My Computer and then left-click
the Properties option. In the System Properties display, click the Hardware tab and then click the
Device Manager button. If the operating system is Windows 10, enter “Device Manager” in the
bottom left Search text box.
b. Repairing False Identification:
If something other than the above CC60XX device is shown, perform the following procedure to
replace the incorrect ID of imaging device with the correct one.
NOTE: This procedure may only be
effective fo
r as long as the CC6000 is attached to the computer’s USB port. If disconnected and
later reconnected, this procedure may need to be repeated
.
i.
Right click on the device listed under “Imaging devices” in the Device Manager display and
select the “Update Driver…” option.
