Portable Connector End Face Geometry Interferometer
Chapter 10: Measurement
Rev B, April 16, 2019
Page 56
STEP 8
•
After the measurement, the scan results will
appear on the Results tab (with its format
determined in part by Scan Settings
configuration).
o
NOTE: If the green circle is not exactly
concentric around the fiber, please conduct
another Offset Calibration (see page 46). If
the green circle, is larger or smaller than the
fiber diameter, please adjust the fiber
diameter to the correct value in the Scan
Settings subtab (see page 41).
STEP 9
•
Remove the connector.
•
Repeat Step 6
– Step 9 to measure the rest of
the connectors.
