THOR Jayco Precept 2021, Owner'S Manual

Page: 60 / 173

58
Section 4: Vehicle Operation
Locate and separate the quick disconnects located in the motor arm channel. Position the
wires from the motor on the outside of the channel.
1. Attach jumper wires to the motor wires. Connect the other ends of the jumper leads
to the 10VDC–14VDC source. If the awning moves in the wrong direction, reverse
the leads.
2. Maintain contact throughout the retraction process.
3. Hold the wires from the motor on the outside of the
channel while closing the awning. This provides access
for opening the awning.
4. When power is restored, use the jumper wires and ex-
tend the awning to access the cable disconnects. Re-
attach the disconnects and secure in the arm channel.
Additional Awning Operation Information
 When rolled out, the fabric may “bounce” creating
a wave like motion in the canopy fabric. This can
creates the appearance of moving jerkily.
 Vinyl may have a tendency to “cling” to the when
not used for an extended period of time. Open and
close the awning in short bursts 2 or 3 times, the
awning will then open normally.
If the awning does not operate, contact the Carefree Service Center. See www.carefreeof-
colorado.com for a listing of service centers.
NOTE: If the awning is equipped with the Direct Response system, this
procedure is not applicable. See the manufacturer’s owner’s manual for
additional information.
Table of Contents Maintenance Record