THOR Jayco Precept 2021, Owner'S Manual, Page: 42 / 173

40
Section 4: Vehicle Operation
Keyless Entry (if so equipped)
The keyless entry system is a battery powered system. The
following is an overview for programming and changing
batteries on the lock system. For detailed information, refer
to the manufacturer’s operator manual.
Battery powered keyless entry system
The battery powered entry system is a 4 button touch pad
programmable deadbolt lock. The 4 buttons are labeled
“1|2”, “3|4”, “5|6”, “7|8”. The button labeled “1|2” is the
same button whether the number 1 or 2 is desired. Please note this handle uses touch tech-
nology. The buttons are activated by touch and do not require pressing the buttons.
Operation
The entry system incorporates proximity sensing to determine when you want to activate the
lock. To operate the lock you first must “wake up” the lock, by touching the wake up area to
the right of the buttons. This will illuminate the touch Pad buttons indicating that the touch
pad is ready for the code to be entered (refer to diagram below).
Preset Factory Code
D epending on your model, the entry system has a factory set code of 3,7,1,5 followed
by the ENTER button. The “ ENTER ” button is the bottom button with the key diagram.
The enter button must be touched after the 4-digit code is entered. The factory code (3,7,1,5)
resets every time the batteries are removed for at least 10 seconds.
Programming New Code - Enter personal code to prevent inadvertent programming.
NOTE: Locks on entrance and baggage doors need biannual lubrication
using a light coat of silicone spray. Conditions such as rain, salt, dust and
pollution may increase the maintenance needs.
Table of Contents Maintenance Record