December 14th 2018
www.thonk.co.uk
8
PROK DRUMS
Eurorack DIY Kit
Instructions
Version 1
16.
Next solder the four 10uF
electrolytic capacitors as shown.
NOTE!
Orientation is vital for this
part. The grey stripe and shorter
leg signify the negative side of
the capacitor, the short lead of
the component should go into
the round hole marked minus on
the PCB.
17.
Next solder in the single 150pF
capacitor into C1.
18.
Now locate the Teensy – this
build uses a Snare Drum but the
procedure is the same for all
Prok modules.
The Teensy included comes
pre-programmed with the Prok
Drums software.