P26
TRoUBLeSHooTinG
eXiT
:
Exits from the recording manager, returns to the last viewed channel.
*This user manual describes the full functionality including the recording function and may not be applicable if the PVR software has not yet been
installed.
7.3.1.5 Recorder Settings*
In the
Recorder Settings
menu you can setup the recording and Timeshift modes.
Timeshift mode:
PAUSE, AUTO, OFF.
Set the Timeshift mode with
tu
.
PAUSE
: In the PAUSE mode, Timeshift can be activated in channel view mode
by pressing
2
.
AUTO
: In the AUTO mode, Timeshift starts immediately in channel view
mode. If you switch channels the previously timeshifted programme will
be deleted and the receiver starts timeshifting the currently watched
programme. During timeshifted content you can use
5 6
,
1
to view the
earlier parts of the programme or to return to the current point.
OFF
: The Timeshift function is disabled.
One button recording:
OFF, ON.
With
tu
you can switch the one button recording mode ON/OFF.
ON
: If you press
4
in the one button recording mode the recording starts in
the set recording length time.
OFF:
After pressing
4
the recording length time window appears on
screen. With
tu
(15 min steps) and
pq
(1 hour steps) you can setup the
recording length time and then press
4
again. During the recording you can
change the recording length time by pressing
4
.
Default Recording Period:
You can setup the default recording time period by pressing
tu
.
*This user manual describes the full functionality including the recording function and may not be applicable if the PVR software has not yet been
installed.
8.0 TRoUBLeSHooTinG
There may be various reasons for abnormal operation of the receiver. Please check the receiver
according to the procedures shown below. If the receiver does not work properly after checking it,
please contact your local Service line or a THOMSON dealer. Alternatively you can send a support
mail via our website: www.thomsonstb.net. NEVER open or disassemble your receiver. This may
cause a dangerous situation and will void the warranty.
Problem
Possible cause
What to do
The display on the front
panel does not light up.
The mains cable is not
connected
The mains fuse is blown
Check that the mains cable is
plugged into the power socket
Check the mains fuse
No sound or picture,
but the front panel
shows red light
The receiver is in standby
mode
Press the On/Standby button