P8
fiRST TiMe inSTALLATion
3.3 connecting multiple fixed LnBs using a DiSeqc
1.0/1.1 switch
Fig. 8
1. Connect the LNBs of your fixed antenna to the inputs of a DiSEqC 1.0/1.1 switch
2. Connect the output or “to receiver” connector of the DiSEqC 1.0/1.1 switch to the SAT IN
connector on your receiver.
3. Refer to section
3.1
or
3.2
for TV and mains connections.
4. Refer to section
7.3.1.1
for Satellite Settings
3.4 connecting to ethernet
Fig.8
Connect a CAT5E cable (or higher quality) to the RJ45 connector of the unit and the other end
to an existing switch, router or modem. The default setting is Auto (DHCP) for automatically
obtaining IPs and DNS. Select Manual in
Menu - Network - Network Settings
to enter own settings if
required. When setting up manually, you need to provide a unique IP address, Netmask, Gateway
and DNS for your receiver. Refer to the manual of your router or modem to setup properly. The
Ping test can be selected to check your connecting, once setup correctly.
4.0 fiRST TiMe inSTALLATion
After all connections have been made properly, switch on your TV and make sure the receiver is
connected to the main power. If you are using the receiver for the first time or restored to factory
default, the
Installation
menu will appear on your TV screen. Press the
tu
buttons to select the
OSD
Language
of your preference.
Country
Select your country.
Pre-installed List
Some countries come with a pre-installed channel list.
If not available for your country, the item is not selectable.
Video Output
Select the output you prefer to use.
TV Format
Select between 16:9FIT. 16:9LB and 4:3LB or 4:3PS
Start Search
If the pre-installed list is selected, the receiver will jump to the first channel
in the list. If no pre-installed list available, the Satellite Setting page will
appear.
noTe:
If Germany is selected as country, a German pre-set channels list from ASTRA
19.2E will be installed. The pre-installed list will work with a single Universal
LNB (LO 9750/10600). If another type of LNB is used, you need to setup the
LNB in the Installation menu, Satellite Setting.
You can continue with the
Installation
menu to scan and install further channels as described
below or go to viewing mode by pressing the
eXiT
button to start enjoying the pre-installed
channels immediately.