MAin MenU
P13
En
g
lis
h
7.1.2 configure the antenna settings for the selected satellite
Satellite
The name of the selected satellite is shown here.
LNB
The setting is Universal LNB (09750/10600) – the most used on the market.
Transponder
Select a transponder, known to carry a signal.
DiSEqC 1.0
Select the switch type in use. 4to1(DiSEqC 1.0) or 16to1. (DiSEqC 1.1)
Select Tone Burst if a Legacy 2to1 switch is used.
Uncommitted
If uncommitted DiSEqC switches are used, select them here. (Advanced
user setup)
Press
tu
to set the LNB power. 13/18 V is the setting for a Universal LNB.
22K Tone
Auto: this setting will follow automatically.
Polarity
13/18 V, this setting will follow automatically.
Motor
If using a motor, press
tu
to choose
DiSEqC1.2/GOTOX
. Then press
ok
to
show the menu for setting the position for your location.
DiSEqC1.2
Move the motor to the right position for locking the signal like explained
below.
Move Continue: press
tu
for moving
West
/
East
. It will keep moving as
long as the button is kept pressed. By pressing once it will move in 1° step.
Move Step(1): press
tu
for moving
West
/
East
in 0.3° step.
Store Position: to store the current motor position for selected satellite.
Goto Reference: to go to the reference 0° position.
GoTo X
Select GOTO X with the
tu
buttons. Press
GReen
to setup your location
coordinates. A pop-up window will appear, in which the following settings
can be made:
Location
:
Press
tu
to select one of the pre-set locations. Choose a location nearest
to you. If you know the coordinates of your place of residence, you can
choose
Manual
and make the following extra adjustments:
Longitude Direction
:
Choose
East
or
West
.
Longitude Angle
:
Press the
0~9
buttons to enter the coordinate.
Latitude Direction
:
Choose
North
or
South
.
Latitude Angle
:
Press the
0~9
buttons to enter the coordinate. When all settings have
been made, press
eXiT
to save the data and leave the window. Now
press
ok
to enter the GOTO X menu.
Move Auto
will move the dish to the
selected satellite automatically. For
Move Continue
,
Move Step (1)
and
Goto
Reference
please see explanation above.
SatcR
Select On, if you use a SatCR LNB, otherwise leave to Off. When On is
selected press
YeLLoW
(Setup SatCR) to enter the Sat setup page.
Position:
Select the LNB A or LNB B.
IF Channel:
Select the IF channel number according to the specifications of your
SatCR LNB.
note:
Any SatCR LNB in the chain needs a different IF channel
number.
Center Frequency:
Select the Center Frequency according to the specifications of your SatCR
LNB.
note:
Any SatCR LNB in the chain needs a different Center Frequency.
Select the store button to finalize your settings or press
MenU
or
eXiT
to leave without storing.